1 1 1 with the exception of fabric fire safety curtain assemblies this standard addresses assemblies that have.
Fire door kick plate requirements.
By definition kick plates are attached to the push side of a door.
Protective plates are usually flat sheets of metal or plastic applied to one or both sides of door faces and located in the lower 16 of the door.
Existing doors or gates with kick plates so long as cavities created by kick plates are capped tempered glass doors without stiles if the top edge of the bottom rail or shoe is tapered at least 60 from the horizontal.
Kick plate is ideal for commercial doors adding a decorative accent and protecting the door surface in high traffic areas.
A 1 1 see annex k for general information about fire doors.
All you ll need is a weekend and some free time.
Kick plates are used where a door may be pushed open with a foot.
Many door manufacturers have tested with non labeled plates up to 48 inches 1219 mm high with no special requirements but nfpa 80 currently requires a field.
Installing a kick plate on your door is a fairly simple process.
Kick plates come in a variety of heights from 10 tall to 16 tall and are usually manufactured in 2 increments.
Door protection plates kick armor mop stretcher kick plates.
Installing door kick plates.
This standard regulates the installation and maintenance of assemblies and devices used to protect openings in walls floors and ceilings against the spread of fire and smoke within into or out of buildings.
There s even magnetic door kick plates available for metal doors.
Nfpa 80 allows non labeled kick plates to be field installed on fire doors as long as the top of the kick plate is not more than 16 inches 406 mm above the bottom of the door.
Easily cleaned for a clean look.
However kick plates can only do so much.
A protection plate may be a kick plate stretcher plate or armor plate installed to protect the face of the door from damage due to traffic and abuse.
The everbilt 10 in.
Nfpa 80 allows non labeled kick plates to be field installed on fire doors as long as the top of the kick plate is not more than 406 mm 16 in above the bottom of the door.
1 2 mm thick brass bronze aluminum or stainless.
Kick the everbilt 10 in.
More product details close.
Nfpa 80 defines a door protection plate as protective material applied to the face of a door and generally made of approximately 0 05 in.
Yes steelcraft doors we are approved up to 48 in height or not to exceed a total 2304 square inches per face.